Gateway 7400 Uživatelský manuál stáhnout pdf (Strana 65)

Replacing or adding a processor 57

To remove the processor:

1 Open the locking lever on the processor socket by moving the lever

slightly out to the side and then lifting it up 90 degrees.

2 Lift the old processor straight up and out of the socket.

To install the new processor:

1 Hold the new processor over the empty processor socket and verify that

pin 1 on both the processor and the socket are aligned. Pin 1 is near the

marked corner.

2 Gently place the new processor into the socket.

3 Secure the processor by lowering the locking lever until the lever latches

into place. The processor will slip into place without pressure when

aligned correctly.

Locking

lever

Pin 1

Processor

8508366.book Page 57 Tuesday, October 23, 2001 11:29 AM

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 155 156

Žádné komentáře

Gateway 7400 Uživatelský manuál Strana 65