Gateway 960 Uživatelský manuál stáhnout pdf (Strana 60)

Installing a voltage regulator

www.gateway.com

Installing a voltage regulator

To install a voltage regulator:

1 Follow the instructions in “Preventing static electricity discharge” on

page 27.

2 Follow the instructions in “Opening the server case” on page 28.

3 If you are installing a new voltage regulator, go to Step 5.

- OR -

If you are replacing a voltage regulator, on each end of the voltage regulator

support bracket, pinch the sides together, then lift the bracket away from

the server. You may need to first remove a heat sink or some memory

modules in order to access the sides of the support bracket.

4 Lift the voltage regulator away from the system board.

5 Insert the new voltage regulator into the voltage regulator slot, then replace

the support bracket.

6 If you removed a heat sink or some memory modules in Step 3, replace

them.

7 Follow the instructions in “Closing the server case” on page 31.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 129 130

Žádné komentáře

Gateway 960 Uživatelský manuál Strana 60